Therm-Tec Crematories are a modular Crematory that is a total packaged system. The units are complete with all components and electrical systems and are pre-tested at the factory before shipment. The burners and controls are constructed under the Underwriters Laboratories # 508A.

The Crematory design is the latest "State Of The Art" construction using composite ceramic lining in the upper section of the unit for low heat transfer and storage, with rapid pre-heat and cool down. The composite ceramics were developed by N.A.S.A. for thermal protection on space vehicles. The floor and side walls (to 18" high) are constructed of heavy duty 3,000 degree°F refractory, monolithically cast for abrasion resistance during loading and clean out.

Therm-Tec Crematories are the only units utilizing a redundant afterburner system to assure "AIR QUALITY" discharge standards are met due to a possible secondary burner failure during a burn cycle. Dwell time in the secondary combustion chamber exceeds 1.5 seconds.

The Crematory construction is NOT the OLD STYLE "Retort" type Crematory that is often costly to repair (hearth replacements), but rather a much improved design which meets the performance and technology levels that are required by today's operators.

The floor of the Crematory is sloped to the back of the unit for liquid control and features sacrificial replaceable hearth tiles.

Loading height is 20" and is compatible with a "Church Truck". No additional elevating (loading) equipment is required.

Remains are removed from the front of the main chamber into a stainless steel receptor.

For heat protection the Crematory has a 5" air cooled facade surrounding the unit. Rear panels are insulated for almost silent operation. 

The burner in the main chamber is positioned for direct flame contact with the body and assures complete combustion.

The crematory is furnished with three 6 foot refractory lined stack sections as standard on all models. 

             Crematory Control Panel                  

Crematory Electrical Controls:    SQC-300

Cremation units controlled by relay logic.
System status is provided by panel indicator lights and digital temperature display.
Continuous fuel and air modulation is automatically controlled by time and temperature.
Timers are electronic and automatically reset (times can be adjusted during cycle by the operator).

Crematory Electrical Controls:   SQC-300M

Cremation units are controlled by a P.L.C. (Programmable Logic Controller) with a face mounted operator interface panel to communicate with the the P.L.C. via a touch pad display.
Temperature in primary and secondary chambers is recorded 7 days a week, 24 hours a day.
System status is provided by panel indicator lights and digital temperature display.
Continuous fuel and air modulation is automatically controlled by time and temperature.
Timers are electronic and automatically reset (times can be adjusted during cycle by the operator).